Wolfspeed Power Applications Forum

Wolfspeed Technical Community:

SpeedFit™ Design Simulator

Simulate and evaluate the performance of SiC-based power circuits and determine the right SiC device in seconds.

Start a Simulation

Categories

CAS480M12HM3

Options
MSW
MSW Contributor Level 1
edited December 2024 in Module Products

Hi,

We are using "CAS480M12HM3" in our application. Can you please share us what is the pitch of the thread used in mounting screw holes.

Thank you.

Tagged:

Comments

  • Forum_Moderator
    Forum_Moderator Wolfspeed Employee - Contributor Level 5
    Options

    Thank you for your post, it has been approved and we will respond as soon as possible.

  • PaulKanatzar
    PaulKanatzar Wolfspeed Employee - Contributor Level 2
    Options

    Hi MSW,

    The dimensions you are looking for can be found on page 10 of the datasheet (Here).

    Thanks,

    -Paul

  • MSW
    MSW Contributor Level 1
    Options

    Can you give me the specification of the thread, I need the 'pitch' of tapped thread. can you please confirm that it is 0.7mm standard one?

  • PaulKanatzar
    PaulKanatzar Wolfspeed Employee - Contributor Level 2
    Options

    Yes the terminal attaches are M4 by 0.7.

    -Paul

  • TBhatia
    TBhatia Wolfspeed Admin - Contributor Level 5
    Options

    Hi, I hope that this answered your question. I will close this discussion for now but if you have a follow up question, please "Start a New Discussion" and we would be glad to support you further.

This discussion has been closed.